Antique Engine and Tractor Ads


Wanted: GEAR (OR SOMEONE TO CUT IT) - Angled teeth, 3.250 dia, 22 teeth Email Buyer PM Buyer
Views Date Posted
544 Mon October 21, 2019


Looking for: I'm needing a gear like the one I have in the photos. OR, I need someone who can cut it (I can send a profile of the teeth as they may be a bit orphan). Its a pretty simple 65 degree angled tooth gear and if I had time I think I could cut it myself. But, I don't have much time and thought I'd see if someone had a gear out there that would work or could cut it for me.

The critical dimensions are 3.250 diameter, teeth at 65 degrees, 22 teeth. It can be from 5/8 wide on up (I could cut it down). The hub you see on it isn't critical as I could add a hub to any gear.....if I can find a gear!

It can be made of cast, steel or bronze. I had a gear off an old mag here that was almost what I needed. But, it had 20 teeth on it not 22.

Look in your box of items and see if you've got something like this. Have cash or items to trade if you do.

Text is probably best. Email is fine also.

Tommy Turner
Magnolia, KY

Keywords: Gear
Location: MAGNOLIA

Posts: 3,268
Registered: December 2004
Location: Magnolia, Kentucky, USA


Register first!
Enginads Subscriptions:
Enter Forum User Name:
Pay For your Classified Ads:
Enter your User Name:

Please read the Terms of Use for this system!

Check your Private Messages. See Today's Smokstak Posts.

For best results on Engine Ads, Register on Smokstak, confirm your email address and then Log IN here on Engine Ads. This will turn on many additional features, such as a contact seller button on the ads. Keep in mind that Enginads and Smokstak are two different web sites, but they now use only one registration system. Also, if you are running ads, Subscribers and Sponsors get more features and benefits on this site.

Only Sponsors may run ads for commercial products.

Find HELP with using our board by Clicking Here.

Be sure to check out the Business Card page for full-time suppliers of engines, parts and services. These are the folks that make this page possible, so please tell them that you saw their ad on Harry's Ad Pages! If their ad isn't here, tell them that it should be!

Enginads Smokstak Old-Engine

How these Gas Engine Ads began: CLICK HERE.

No portion of this page, text, images or code, may be copied, reproduced, published
or distributed in any medium without the expressed written permission of the copyright holder.

All use is subject to our TERMS OF SERVICE
EnginAds® is a Registered Trade Mark - A Community of Antique Engine Enthusiasts
Copyright © 1999 - 2019 by Harry Matthews - P.O. Box 5612 - Sarasota, FL 34277