|
|
For Sale: Fairbanks Morse Model Z Type D
posted by mbdittmar Westminster, CO
Fairbanks Morse Model Z Type D engine, 1.5 hp,
throttle-governed ; new gas tank. Mounted on cart.
With crank. Excellent runner, great condition.
Lots of pictures at
http:&s ...
|
160
|
Great
|
$375.00
|
|
Wed November 19, 2008 6:32pm
|
|
|
For Sale: Rocker arm or tappet stand for 4hp Titan (repro)
posted by Rob Charles NJ
Hi All, Unused rocker arm stand with the pin for a
4 hp Titan engine. Machined and ready for use.This
only fits the throttled gov. engines and not the
hit and miss Famous. $16 ...
|
54
|
Great
|
$160.00
|
|
Wed November 19, 2008 3:10pm
|
|
|
For Sale: 4 H.P. IHC FAMOUS THROTTLE GOVERENED
posted by Engineguy fargo, North Dakota USA
Hi there
This engine is a 4 hp IHC Famous throttler it
starts easily and runs all day. It has been
restored and a set of trucks made for it. This
engine has a clutch pull ...
|
695
|
Great
|
$3,900.00
|
|
Mon November 17, 2008 8:16pm
|
|
|
Wanted: 3 hp. International M parts
posted by doug s New Holstein, WI
Looking for a throttle butterfly assy. and a
governor yoke. For a 3 hp Internation M engine
with a ignitor. If any body has them to sell let
me know? T ...
|
115
|
None
|
n/a
|
|
Wed November 5, 2008 7:01am
|
|
|
Wanted: Economy 1 3/4 Crank, Throttle control, etc
posted by Tim Claremont Rochester, NY USA
Need a good, bare crank. Also need the throttle
control that goes on the pushrod, and a carb, and
a governor.... Aw heck.. I need just about
everything. Please let me know wha ...
|
99
|
None
|
n/a
|
|
Mon November 3, 2008 1:38am
|
|
|
Wanted: throttle control arm 10HP FM Z
posted by Jim Sherman Vashon, WA
I am looking for a throttle control arm for an
early tank cooled 10HP Z. The one shown in the
photos is for a 15HP and has a slight bend, the
one needed for the 10HP is straig ...
|
176
|
None
|
n/a
|
|
Sun November 2, 2008 2:23am
|
|
|
For Sale: 6HP INTERNATIONAL HARVESTER
posted by Tom Herd Piedmont, S. Dakota USA
This is a running engine with very good
compression and a good mag. I start it with a
battery then switch over to the mag. It is low
tension - throttle governed. The mixer has ...
|
537
|
Good
|
$1,850.00
|
|
Thu October 30, 2008 11:35pm
|
|
|
Wanted: IHC 1 1/2 HP M Carb, Throttle Rod, Gov Rod to Throttle
posted by gpitt1960 Tuscumbia, AL USA
I am in need of a Carb or good internal parts to
repair my carb. I need the Rod from the Govener to
the throttle. Also need a good original fuel pump.
My IHC M is dated at 192 ...
|
130
|
None
|
n/a
|
|
Fri October 24, 2008 2:19am
|
