|
|
For Sale: A.B.Farquhar horizonal steam 5.5 x 8
posted by mezking nicholls ga
i have a complete A.B.Farquhar horizonal steam
engine #15557 made in york pa. size is 5.5 x 8
with 36" flywheel by 8", has 3 ball flyball
governor that needs rebuilt,cleaned a ...
|
410
|
Good
|
n/a
|
|
Tue March 9, 2010 8:21pm
|
|
|
Auction: Horse drawn Slushing Bucket Nice shape
posted by Tony Kautza Aniwa, Wisconsin
Nice old horse drawn slushing Bucket see auction
for details can deliver to Le Seuere or Baraboo
swap meets
|
37
|
None
|
n/a
|
|
Sat March 20, 2010 2:03am
|
|
|
For Sale: Nice ORIGINAL Jacobson sideshaft gas engine catalog $150
posted by Shelby Babcock  Caro, MI
Here is a chance to own a very nice piece of
engine literature. It is a Jacobson engine
catalog, I would say before 1910. The pictures
don't do it justice. It is in very good ...
|
62
|
Great
|
$150.00
|
|
Fri March 19, 2010 9:03pm
|
|
|
For Sale: Oliver 2 bottom plow on steel
posted by Tim M Hamilton,OH
I have for sale a nice Oliver two bottom plow on
steel wheels.One lever has a short section of
steel pipe added to it and it doesn't have a wheel
on back (not sure if this mod ...
|
146
|
unrated
|
$175.00
|
|
Fri March 19, 2010 12:07am
|
|
|
For Sale: Gardner air compressor pump
posted by largeengineguy33 Oakville, Ontario Canada
For Sale,
Gardner air compressor pump fully restored and
ready to pump air, pulley included was taken off
for restoration the pulley is in great shape.
pictures of the pull ...
|
170
|
Great
|
$180.00
|
|
Thu March 18, 2010 2:14am
|
|
|
For Sale: 12 hp Gould Shapley
posted by Mike Synnott Nottawa Ontario Canada
12 hp Gould Shapley hopper cooled, throttle
govern
webster mag, good shape, clutch pulley available
but not included
|
125
|
unrated
|
$6,200.00
|
|
Thu March 18, 2010 1:50am
|
|
|
For Sale: 10hp International "M"
posted by Mike Synnott Nottawa Ontario Canada
!0 hp International "M" high tension with clutch
pulley no cbw great shape.
|
147
|
Great
|
$6,500.00
|
|
Thu March 18, 2010 1:35am
|
|
|
For Sale: NICE IHC LB 3-5 gas engine on trucks $500
posted by Shelby Babcock Caro, MI
I have a very nice 1944, IHC LB 3-5hp for sale. I
bought this engine about 5 years ago. Since then I
have had the mag completely rebuilt, (over $150)
had the gas tank repaired ...
|
243
|
Great
|
$500.00
|
|
Wed March 17, 2010 10:48pm
|
|
|
For Sale: 1938 MM KTA Waterloo
posted by catdozer Bracebridge, Ontario
1938 MM KTA Waterloo. Everything redone on this
tractor paint was finished July 2009. Absolutly
beautiful shape and excellent running,cleats are
original but have been built b ...
|
266
|
Great
|
$15,000.00
|
|
Wed March 17, 2010 8:40pm
|
|
|
For Sale: Large Steam Tugboat Engine
posted by catdozer Bracebridge, Ontario
For Sale Antique Tugboat Steam Engine, in great
shape. please email for more information.
|
416
|
Great
|
$4,000.00
|
|
Wed March 17, 2010 8:18pm
|
|
|
Auction: ebay
posted by MartyWB Reno, Nevada
ebay no reserve
Caterpillar Ten. Engine is free, has complete
manifolds and carburetor with fuel strainer.
Original oil pressure gauge. Ten has all tags.
Under-carriage in ...
|
171
|
None
|
SOLD!
|
|
Wed March 17, 2010 6:43am
|
|
|
For Sale: Galloway cart, Wards Metal Lathe, Wico EK,
posted by John Raney So. E. Michigan USA
Nice Galloway cart, no cracks, welds or chips.
$250..
Wards metal lathe(South Bend?)everything works
good, all gears are in great shape. Orignal cast
legs, quick change gear ...
|
465
|
Good
|
n/a
|
|
Wed March 17, 2010 2:34am
|
|
|
For Sale: 1932 McDeering 1020 restored on rubber W/electric start
posted by Rob Charles NJ
Posting for a puterless friend but I'll answer
emails.Older restoration. The electric start setup
was professionally built by me.Uses an IHC starter
and an IHC ring gear mount ...
|
298
|
Great
|
$3,250.00
|
|
Tue March 16, 2010 5:05am
|
|
|
Auction: Superior Oil Field Eng Mag,set up, Head,Water Covers
posted by PDWintn Bridgeton, NJ
There is a complete working (Hot) mag set up with
mag bracket, Head and side plate water covers.
Allin great shape.
|
64
|
None
|
n/a
|
|
Sun March 14, 2010 4:45pm
|
|
|
For Sale: Harley Davidson #3 aircooled sparkplug box.
posted by Alex F Langley, BC Canada
Heres a near mint CHAMPION Harley Davidson script
aircooled #3 sparkplug plus the original cardboard
box. Plug is in near mint shape and if it was used
it was very little. The ...
|
121
|
Great
|
$100.00
|
|
Sun March 14, 2010 1:44am
|
|
|
Wanted: 1924 Farmall Regular Transmission
posted by PB in IN greensburg,IN
Looking for a 1924 Regular transmission. The one I
have for mine is in bad shape the rear flange is
all cracked and has been patched before some
welding some brazing. Most of ...
|
90
|
None
|
n/a
|
|
Sat March 13, 2010 7:48pm
|
|
|
For Sale: Briggs & Stratton FH Head
posted by Jason Wisconsin
Nice & clean head and rocker arm for a Briggs FH
engine. It is painted black but looks to be in
great shape. There looks to be a new valve
installed in the head. $50 ship ...
|
108
|
unrated
|
$50.00
|
|
Fri March 12, 2010 4:26pm
|
|
|
For Sale: 2 midland garden tractors and 1 wards simplicity
posted by david boothby bethel ohio united states
I have 2 1948 montgomery wards midland garden
tractors for sale. both with sulkys. not original
sulkys though. both have wisconsin ab. 3/hp
engines. one needs tires and rims. ...
|
226
|
Good
|
n/a
|
|
Fri March 12, 2010 12:57am
|
|
|
For Sale: 1977 Ford Firetruck
posted by Terry Hart Wiggins,MS
This is a 1977 Ford F-800 Firetruck and it has a
389 gas engine and 5 speed transmission with a 2
speed rear and it only has 27,000 miles on it and
all works and pumps with al ...
|
57
|
Great
|
$10,000.00
|
|
Thu March 11, 2010 2:18am
|
|
|
For Sale: 8HP Goulds, Shapely, & Muir
posted by Tom Winland Columbus, Ohio
8 HP Goulds Shapely & Muir, runs great, 40"
flywheels, 6" bore, 10" stroke, flywheels run
true, very neat fuel injected engine, flyball
governor, nice large engine, full sub b ...
|
573
|
unrated
|
$3,650.00
|
|
Wed March 10, 2010 3:05am
|
|
|
For Sale: J S Schofield & son builders horizonal steam engine curved flywheel
posted by mezking nicholls ga
i have a complete J S Schofield & son builders
horizonal steam engine E11 made in macon ga. aprox
size is 6 x 8 (not stamped)with 52" curved
flywheel by 8.5", don't know the o ...
|
183
|
Good
|
n/a
|
|
Tue March 9, 2010 8:52pm
|
|
|
For Sale: A.B.Farquhar horizonal steam engine 10 x 12
posted by mezking orange park fl 32003
i have a complete A.B.Farquhar horizonal steam
engine made in york pa but sold in jacksonville fl
at a old dealer years ago. serial# 21083. still
have both brass tags on valve ...
|
140
|
Great
|
n/a
|
|
Tue March 9, 2010 8:11pm
|
|
|
For Sale: Wizard magneto & igniter
posted by Roger Kirschenman Nebraska USA
Wizard type 61 model 2 # 258259 magneto.The
mounting holes on the igniter are 3" C to C. bolt
holes are 1/2".This magneto has a big blue spark &
is ready to go to work.I will ...
|
187
|
Great
|
$500.00
|
|
Tue March 9, 2010 7:52pm
|
|
|
For Sale: Toro Master Parts Catalogs
posted by 1938Sears Sherrard Illinois, USA
I have 3 Toro Master Parts Catalogs. Each one of
these is over 6" thick and are jam packed with
information on anything from tractors to edgers,
to generators. Years range f ...
|
69
|
Good
|
$75.00
|
|
Tue March 9, 2010 3:43am
|
|
|
Wanted: IHC 6hp M - Head and Pulley
posted by enginekid89 Anderson SC
Im Looking for a head for a 6hp Ihc M. It needs to
be in good shape, with no cracks, breaks, or
welds. Also am interested in a pulley for the same
engine. Please let me know i ...
|
51
|
None
|
n/a
|
|
Tue March 9, 2010 3:17am
|
|
|
For Sale: Fairbanks model A home light plant
posted by oldironlindy Kimball MN US
In very good shape. I have not had it running yet
but should not be hard to get it going.
$1200/Best offer
320-398-2622
|
487
|
unrated
|
$1,200.00
|
|
Mon March 8, 2010 1:13pm
|
|
|
For Sale: 25-85 Nichols and Shepard Double cyl Rear mount
posted by George White Bowman, North Dakota USA
THE SALE OF THIS ENGINE IS CURRENTLY PENDING,
...
|
903
|
Good
|
$38,000.00
|
|
Mon March 8, 2010 4:20am
|
|
|
For Sale: 2 IHC 1 1/2 Horse model M over strike ignitor engines
posted by Kris Eckhoff Cole Camp Missouri
I have a early model M with over strike ignitor
looks complete been in a fire great parts engine
all iron looks good and I also hvae a spark plug
engine in the same shape will ...
|
342
|
unrated
|
$350.00
|
|
Mon March 8, 2010 1:39am
|
|
|
For Sale: 6hp Fairbanks Morse Z $775
posted by Jon Rozevink Holgate, Ohio
Here is a nice 6hp Fairbanks Morse Z engine. It
seems to be in good shape and ready to run. There
is a band on the head but I cannot see where it
would have been cracked at. ...
|
499
|
Great
|
$775.00
|
|
Sun March 7, 2010 10:06pm
|
|
|
6hp IHC Victor Screen Cooled Hit and Miss $5250
posted by Jon Rozevink Holgate, Ohio
Here is a nice 6hp IHC Victor screen cooled
engine. It is in good shape and ready to run. It
has been sleeved. It has a new screen cooler and
brass rotarty water pump. This is ...
|
575
|
Great
|
$5,250.00
|
|
Sun March 7, 2010 9:34pm
|
|
|
For Sale: Olds 3 h.p. Model AA - Air Cooled
posted by Hendy Salem, Oregon USA
For Sale: very early, rare, air-cooled Olds Model
AA 3 h.p. engine with a 4" bore, 22" flywheels--in
good shape. Previous weld on cylinder sleeve and
piston. They did a ver ...
|
524
|
Good
|
$3,500.00
|
|
Sun March 7, 2010 4:16pm
|
|
|
For Sale: JAEGER 2HP 2 CORN GRINDERS
posted by bbhf Norwalk CT USA
JAEGER 2HP ENGINE IN GREAT SHAPE WITH CRANK,
PULLEY, ENGINE CART, TWO BELTS, TWO CORN GRINDERS
READY TO RUN:ENGINE HAS AN OLD REPAIR TO THE
ROCKER ARM: PLEASE SEE PIC: LOCAL P ...
|
344
|
Great
|
$1,200.00
|
|
Sat March 6, 2010 3:13pm
|
|
|
For Sale: Nice Crocker Wheeler Motor
posted by Mark Mohney Brookville, PA USA
Good Shape Turns free thats all I know info (814)
715-1043
|
255
|
Great
|
$100.00
|
|
Sat March 6, 2010 2:01am
|
